Tractor Talk Discussion Board |
Re: Ford 650 running rich
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jerry B on May 01, 2001 at 09:16:48 from (162.114.24.109):
In Reply to: Ford 650 running rich posted by Robert M. Rottman on May 01, 2001 at 08:23:48:
Setting the timing by light would be the best way. However, lacking a timing light or timing mark you can set the timing by ear. Start by bring the engine to operating temperature. Open the throttle to wide open, high idle. Advance the distributor until you hear the RPM's drop slightly. Retard the timing until the RPM's drop again. Now advance the timing to a point mid way between the 2 extremes and maybe even a little farther toward advance than the exact mid point. This should get you very close to the correct timing.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|