Posted by Ultradog MN on April 11, 2010 at 19:48:09 from (71.34.14.62):
We have to pull the pistons on a 971 Ford gasser. I was under it today with the pan off checking things and and letting the oil drip into my eye and down my cheeks without so much as flinching. So we do this evenings and weekends at a giant machine shop where my friend works. The place has a pair of 5 ton bridge cranes. Why couldn't we pick the tractor nose straight up in the air and work on it that way. Drain All the fluids out of it, pull the head, lift it so it sits on it's rear and do the rest standing up. Yeah you can remind us about the safety issues but believe me, we wouldn't try this at home. Be fun to do wouldn't it? If you could? Be easier too I think. If you have to pull the pistons anyway? Because whoever "rebuilt" the engine put all pretty new sleeves, pistons, rings, etc but didn't know you have to renew your upper rod bushings once in a while. But not to get side tracked there. Gonna hang the tractor one night this week I hope. Maybe can get some pictures.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.