Posted by teddy52food on April 22, 2010 at 19:47:41 from (209.237.115.177):
In Reply to: Re: OT????????? posted by John T on April 22, 2010 at 13:34:54:
John; The laws haven't been changed. All I ask is that you get a copy of Joe Newman's book & he will explain how it is done. His last prototype that he hand built weighs 7500 pounds with a 1650 pound permanent magnet rotor on a 3 inch shaft. A conventional motor that size would require thousands of watts to run it with cables as big or bigger than your thumb. Joe's machine (called The Big Eureka) runs on solar panels,9 volt flashlight batteries or a small ac to dc transformer, all of which are low wattage devices. The imput wires look like 14 or 16 gauge wires, not big cables. Check it out on his website & see for yourself. Thanks, Don.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
