Tractor Talk Discussion Board |
Re: Brake fluid
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by big fred on June 09, 2001 at 16:46:52 from (208.51.245.93):
In Reply to: Brake fluid posted by Bob on June 09, 2001 at 14:01:55:
Bob, I am planning on doing this to my '50 Ford 2-ton truck, but haven't commited to it yet. I did a bit of research and it looks like you really don't want to mix the DOT-5 (silicone) with the DOT-3 brake fluid, so you would need to take the entire brake system apart and clean it all thoroughly. In addition, since water will not mix with the silicone fluid, any water will tend to sink to the lowest point in the system and pool there. If this is the wheel cylinder you have a problem. In addition, at least on my Ford, there is a material incompatibility in the brake light switch which means I will need to replace that switch occasionally. You might be better off just replacing your DOT-3 more frequently on your old cars, but if you do go with DOT-5, clean out all the old DOT-3 thoroughly first. Good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|