Tractor Talk Discussion Board |
Re: Balers Round or Square
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmer-Gene on June 21, 2001 at 13:23:39 from (207.230.216.36):
In Reply to: Balers Round or Square posted by AJZ on June 21, 2001 at 11:26:06:
depends on how much exercise you want, small squares need to be put inside out of the weather big rounds are a lot faster to make and they usually leave them outside where they mold down about 6" all the way around Horses can't take the mold gives them the heaves [lack of wind] which is why they get small squares cattle are good processers of mold but they usually won't eat it so they get big rounds. My milk cows get small squares in the barn and the heifers get big rounds outside. One round will equal about 15 sm squares lot easier to drop a big bale in feeder with tractor than lug 15 small squares.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|