It depends on a number of things, including what your main is capable of supplying, the water pressure in the main, how long the various lines are in your system, how big they are and how long this 1/4 inch ID hose is. If it turns out that the 1/4 inch segment is the single greatest restriction in your system, it could be huge. Increasing the ID from 1/4 inch to 3/4 inch will increase the cross-sectional area by nine times, meaning potentially nine times as much flow!
Probably the restriction caused by the short 1/4 inch ID segment is relatively small compared to the pressure drop in the rest of the system. But I would certain try to replace it with something bigger. And for any long lines, such as those going to your tanks, one inch pipe is the minimum you should use. A 3/4 inch pipe has 2.25 times the cross-sectional area of a 1/2 inch pipe, and a one inch pipe has four times the area.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.