Posted by John T on June 02, 2010 at 10:59:56 from (66.244.97.31):
In Reply to: Diode posted by JD2840 on June 02, 2010 at 10:40:23:
The diode is used to prevent the alternator from backfeeding the ignition coil so when you turn the switch off the tractors STOPS running.
About any diode rated at say 3 amps (a bigger rated is okay if thats all you have like a 5 or 10 amp or more) and with a voltage withstand rating of say 50 volts or more (again a higher voltage rating like 100 or more volts is okay) will suffice. NOTE its polarity sensitive and MUST be wired correct, the cathode towards the alternator assuming Neg ground.
I have used a 10 ohm or so (or larger) resistor instead of a diode as it can still prevent the backfeed run-on problem PLUS provides at least some degree of safety current limiting.
It (excitation circuit with diode or resistor) wires between the ignition switches IGN output or the ignition coils input (same electrically) and the small No 1 alternator terminal. I wire the other No 2 small voltage sense terminal direct down to the alternators big main output stud
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Cautionary Tale - by Ian Minshull. In the early 1950s my father bought an Allis Chalmers B and I used it for all the row crop work with the mangolds and potatoes, rolling and the haymaking on our farm. The farm and the Allis were sold and I have spent a lifetime working on farms throughout the country. I promised myself that one day I would own an Allis. That time event
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.