Posted by KEB1 on June 03, 2010 at 21:19:57 from (97.124.128.182):
In Reply to: Gulf oil well posted by Earl in Kentucky on June 03, 2010 at 06:56:57:
And just what makes you think the pipe is soft enough to crimp? When was the last time you tried to crimp an iron water pipe? Even if you did manage to crimp it, what makes you think you could get it tight enough to stop a high pressure leak without it cracking?
A lot of people on this site seems to have an answer to everything, but none of you seem to understand the implications of what you're proposing. It's easy to bash what you don't understand.
Politicians are mostly sociopathic idiots (they have to be sociopathic to be willing to step on all the people they do to get to the top), but there are an awful lot of smart people involved in the oil industry who I'd be willing to bet know a whole lot more than any of you about how to handle a leaking well. Who do you think designs, builds and operates the drilling rigs.
I get tired of people who have no concept of what's involved in solving a problem acting like the people who are working on it don't know anything.
Keith
PS...no, I don't work in the oil industry. I design spacecraft for a living.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.