Tractor Talk Discussion Board |
Re: Kaboom--battery questions--Kaboom
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Stan in AL on July 02, 2001 at 07:19:09 from (65.162.104.6):
In Reply to: Kaboom--battery questions--Kaboom posted by Brad Wies (DC-4 DUDE) on July 02, 2001 at 06:06:44:
When batteries are charging they produce Hydrogen gas. It has no odor of it's own, so you're not likely to smell it. If a battery is charging normally, the amount of gas produced isn't very large, and it vents through the caps and escapes into the air. The normal air circulation takes care of it. Hydrogen is lighter than air, so it goes up, out of the way. If the battery charges excessively fast, it can produce lots more hydrogen than normal, and if some of it gets trapped in an enclosed space, and it reaches an ignition source (which can be heat or spark I believe) then it can explode. I've seen 2 batteries explode, luckily no one was hurt either time. If a battery is run down, and you crank the vehicle to recharge it, let it run for a while, then shut it off, then attempt to jump-start it again, you can provide a spark if you make the last connection of the cables at the battery post. That's what I think caused one of the battery explosions I had. It was on a dune-buggy which had the battery mounted in the open. That's why the safe way to connect cables for jump-starting is to make the last connection at a grounding location away from the battery. By the way, hydrogen is the gas that was used in the Hindenburg dirigible, anyone seen the film-clip of the fire that destroyed it? Not a pretty picture. Hope this makes sense to you, and good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|