Tractor Talk Discussion Board |
Re: Removing Block from 1950 A John Deere
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Karl Bader on July 05, 2001 at 04:33:27 from (209.92.35.70):
In Reply to: Removing Block from 1950 A John Deere posted by Ken on July 04, 2001 at 16:15:07:
taking the block out of a Deere is real easy, and I mean real easy. First you have to take the hood off of the tractor, in order to do this you have to take the small piece of tin (the medallion) off of the front of the tractor, then you can take the steering shaft of, be careful as there are 2 bearings that come out with the shaft. Then take your side curtains off, there are 3 bolts on the hood side and there are 3 hidden in the steering column side. then take of the hood and gas tank as one piece making sure all is disconnected. Then take off the fan and governor assembly, then the water manifolds (upper and lower) then you are at the tappet cover, take that off, then take off the rocker arms, pull out the push rods, then take off the head, and finally the block just unbolts, and the rods also unbolt (there is a cover on the top of the tractor which is right in front of the pedestal which gains you access to this. Presto then you have the block out. What honestly would help you a great deal (I know it helped me before restoring my B I had no idea what I was doing) is the Engine Rebuild Video For John Deere Tractors, they take you step by step and you can't get confused by the manual! Click on the Parts Supploers link and then click on the videos link. I guarentee that it's money well spent. Although buyng the parts manual and service manual help a whole lot. I hope this helps! If you need help feel free to e-mail me at kbader@badertech.com and good luck! Hope this helps! Karl
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|