Posted by 135 Fan on June 29, 2010 at 10:34:27 from (68.149.56.30):
In Reply to: Weak, eh? posted by Bob on June 29, 2010 at 08:12:27:
It does seem odd that someone that sells them can't spell them correctly. There is some mis information on here. First of all you can't lump all finish or all flail mowers in the same category. That would be like comparing the cheapest garden tractor to a commercial golf course mower. In heavy cutting a good flail like a Mott/Alamo will take less HP to run than a comparable rotary mower. A flail with enough power behind it can cut tall grass to a finished look in one pass. Again a good flail like an Alamo. Like rotary mowers, flails also come in rough cut and fine cut versions. Flails can also come in reverse rotation. A reverse rotatation fine cut flail will give the nicest cut of any flail. In fact a flail mower could be used for any application except a golf course green and have been used on sod farms. A good flail mower will cost a lot more than a rotary finish mower but will last a long time if properly maintained and used. Flails are the safest mowers because they will throw any rocks or debris into the housing and not out like projectiles. The knives are designed to fold around obstacles as well. If the field you're mowing isn't maintained like a normal lawn and is rougher with perhaps some debris, then your friend is correct that a flail would be a good choice. If it's a nicer lawn a rotary finish mower will do a nice job and cost less. If you do look at flails, compare the type of knives and construction of the machine with an Alamo. They are the standard to compare with. They have much heavier construction and HD components through out. Lots of municipalities and railroads use Alamo flails because of their safety and HD construction. I hope I've cleared some things up for you. Dave
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.