Posted by James22 on July 01, 2010 at 19:02:41 from (207.179.221.63):
In Reply to: disc harrow power? posted by Chas. Ont. on July 01, 2010 at 15:37:55:
I pulled a 21 ft IH490 with 80 hp JD 830 with duals in stalks a couple inches deep. Couldn't pull it with it sunk to the hubs, not enough traction. So as was stated earlier, if it is an offset disk made for deep tillage better pass, otherwise buy it. Also have a 14 ft JD BWA that was a good match for the 730 but only a toy for the 830. Finally have a 18 ft IH 480 that was a good match for 830 but for the 730 it was quite a task.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.