Posted by noncompos on July 08, 2010 at 19:57:40 from (70.58.204.25):
In Reply to: 1936 Huber HK posted by SweetLeah on July 07, 2010 at 08:40:26:
Leah: I do regret being the (probable) bearer of ill tidings, but my 38 Victor catalog, which is pretty good (but not perfect) at listing what various engines were used in, sez the CHS (43/4x61/4) and the CHK 51/8x61/4, were used in (hold your breath!!) Huber and Kay-Gee, period. (That catalog, under Kay-Gee 18-35 (Keck-Gonnerman) shows Buda's to 1935, the Wauk CHK from 36 to end of prod in "WWII". There're probably as many K-G restorers as Huber restorers. My engine lists show several other "C" engines, but the only one in my catalogs is the CU 43/8x51/4, used in Huber Light Four 12-25, which sounds too light even if it did fit or could be Mickey-Moused in. When you have a positive ID I can run my catalogs (no big deal) for other installations. With sympathy, Bud
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
