Posted by Robert Neal on July 13, 2010 at 19:49:01 from (76.217.100.174):
I have a 1958 IH 460 diesel utility tractor. The other day it developed a pinhole leak in the main hydraulic hose going from the pump to the distribution valves. I removed it and took it to a hydraulic hose repair shop. After going to the third shop, I found someone who said he could repair it. He put a new end on the top end and welded the bottom end piece onto a new end on the bottom. Using new hose of course. However, now it does not fit because it seems to be about 3 inches to long and there is only a total of 4 inches of rubber hose now anyway. The real problem is what before was a simple right angle fitting, now is pipe with a 3 inch radius. That is how hydraulic hoses are made now, apparently.
Any suggestions as to what I can do now? I can't even start it because it would pump all of the oil out. Anyone know where I can get a replacement?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
