Posted by JDseller on July 14, 2010 at 21:45:18 from (208.126.196.117):
In Reply to: john deere 110 posted by Edwin P. on July 14, 2010 at 15:33:50:
No the drive system is different from the gear drives and the hydros. The motor sets sideways in the gear drives and the mower deck is driven off of the right side. The hydros motor sets length wise and is driven off of the front of the motor. That 140 deck is 41 inch deck. They counted the width from end of blade tip to blade tip. If you want a wider deck, one off of the newer hydros will fit. 300-317. Your only difficulty will be getting the right drive belt. They use three different ones and it depends on the deck and model of tractor which one you need. Might need to just take all three and set the adjusting knob in the middle and see which one is the correct tension. Then just return the unused ones. Then KEEP the paper sleeve. I stapled mine to the shop wall so it does not get lost.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
