Posted by El Toro on July 16, 2010 at 04:01:42 from (74.103.74.58):
In Reply to: 1966 farmall 140 posted by Dave Surdi on July 15, 2010 at 22:47:15:
You need to disconnect the gas line at the carburetor and see if there's a full stream of gas from the tank. Hold a clean container and catch the gas. If there's just a trickle of gas there's dirt or rust blocking the gas flow. If there's an inline filter you probably need to remove that if it's not for a gravity flow system.
Did you soak that carburetor in carb cleaner and clean all the jets? This is very important since this gas may have gummed up your carburetor inside and is blocking the gas flow to your engine.
Hold your hand over the throat of the carb and see if there's good suction on your hand while a helper make's an attempt to start the engine. If there's very little suction you may have a vacuum leak. You need good manifold vacuum to suck that fuel into the engine. Spray a little bit of that starting fluid around the intake manifold gasket between the engine and intake manifold while someone makes an attempt to start the engine. Be sure the ignition switch is in the on position and see if the engine fires. If it does your intake is leaking and may need tightening or replace the gasket. Hal PS: Don't use too much of that starting fluid as you can damage the engine.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
