Posted by glennster on July 28, 2010 at 05:56:30 from (76.217.101.185):
In Reply to: gas tank dent posted by javan on July 27, 2010 at 20:27:56:
depends on where the dents are. if they are accessible thru the filler opening, you can use a length of 1/2 inch or 5/8 inch round steel stock and fabricate a "pick" to get inside and push the dents out. round the end of the rod on a grinder then dress it so its smooth, then make some bends in it so you can fish thru the opening and get to the backside of the dent. if its not accessible from the inside, a stud welder is the best option, a local body shop will have one and they can pop the dents for you. another option is to solder some nails, head down on the dent and use a vice grip to pull them up. work around the dent with a body hammer when pulling it up if it has high spots, then heat the nail to release the solder. if you just want to cannibalize it, use a pick hammer, beat the dent in so the area is low, then bondo over it. not the right way to do it, called the "cave and pave method"
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
