Posted by Bob in MN on August 15, 2010 at 09:34:39 from (98.132.195.22):
Good to hear that you had such good luck with your hoe.
I"m mounting mine on a Allis Chalmers D-17 series I. That is why I chose to go independent on the hydraulics.
This hoe does have the skid steer mount on it w/a JD conversion adapter to 3 PT.
This hoe was mounted on a JD 1020 gas tractor. Does that tell you JD guys out there which way these valves might be set up, open or closed?
The parts catalog indicates that valves for the BOOM, SWING, DIPPER have relief valves built into them but not in the bucket valve. This still does not eliminate the need for a SYSTEM relief valve, does it?
My setup is an assy. of parts that were available to me and not necessarily the best choice for the application.
I am using a FARMHAND PTO pump. I believe it is 10 GPM. The tank is 15 GAL. At this point there isn"t a cooler attached. I have a fan/radiator style cooler I could use.
Thanks again to all of you who have responded. Bob
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
