Posted by Dick L on August 17, 2010 at 13:16:09 from (72.11.21.10):
In Reply to: FINISH MOWER INSIGHTS posted by Allen L on August 17, 2010 at 11:53:30:
I have mowed witha woods L59 belly mower under my Allis Chalmers B for over ten years and just had the first bearing get noisy. I took it down and am replacing all the bearings and painting every thing. The have taper bearings like wheel bearings. The bearings didn't look all that bad.
I mow 3 acres at home most weeks and mulch a 4 acre hay field a coupla times each year. I also haul it up to the factory and mow 4 avres around the buildings several times a year. Purty tuff unit. It does not do as good of a job as my 5 foot Simplicity mower I used for 15 years under a Simplicity 9523 same as an Allis 5020. I just like showing off my Allis Chalmers B.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
