Posted by Goose on August 18, 2010 at 19:31:42 from (67.63.68.13):
In Reply to: paint recommendations posted by Dan W MN on August 18, 2010 at 16:39:09:
I"d use automotive laquer based primer-surfacer followed with urethane enamel with hardener. If you want a little icing on the cake, shoot your sheet metal with two stage base/clear.
If you use urethane, it's important to use hardener. That's what gives the paint it's gloss and durability. And remember when using hardener, once the hardener is added it's going to set up in about four hours whether it"s on sheet metal or in the gun.
I have a cousin who owns probably well over a hundred old tractors, and he refuses to use hardener because he wants to keep any leftover paint for future use. And his paint jobs look it. I keep telling him if he used the hardener his paint jobs would look infinitely better and add a lot more value to the tractor. But--he doesn"t see it that way.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.