Posted by robersw on September 15, 2010 at 09:23:48 from (134.223.116.201):
In Reply to: Bale Processor posted by Jim Johnson on September 14, 2010 at 08:41:17:
We have a Vermeer BP5000. We have had it for about 5 years. We have experimented with about every hay savings device available. Our guesstimate has been that this processor eliminates around 1/3 of the hay that would go to waste by traditional feeding methods. With that said, we have expected that payoff for this processor is 6-7 years based on our volume of feeding.
The main con for this type of device is that you MUST feed everyday. A lesser con is that bales stored outside tend to hang up in the processor. If I understand Vermeer correctly, they have fixed that issue in later models. Another con is that we must remove all twine before using the processor, even sisal, because it wraps around the drum and prevents the flails from swinging (newer versions are supposed to have a built in knife to eliminate this).
The main pro, of course, is there is almost no waste in what is fed. Once those outside stored bales are ran through the processor, they hay is so mixed together that the cows no longer pick through what they want to eat, so they clean it all up. Another pro is that we can move our feeding area around daily to reduce the mudhole that comes from stationary feeding.
The biggest con on the BP5000 itself, was that it was sold only with a 1000 rpm gearbox. The newer models offer 540 or 1000. Another improvement on the newer processors is that the discharge chute is on the right side instead of the left. Also, the newer processors can use accessories that mix feed/minerals in with the hay as you feed.
Hope this helps.
Scott
This post was edited by robersw at 09:27:25 09/15/10.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Grain Threshing in the Early 40's - by Jerry D. Coleman. How many of you can sit there and say that you have plowed with a mule? Well I would say not many, but maybe a few. This story is about the day my Grandfather Brown (true name) decided along with my parents to purchase a new Ford tractor. It wasn't really new except to us. The year was about 1967 and my father found a good used Ford 601 tractor to use on the farm instead of "Bob", our old mule. Now my grandfather had had this mule since the mid 40's and he was getting some age on him. S
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.