Posted by Adirondack case guy on September 18, 2010 at 07:36:12 from (67.252.92.228):
In Reply to: Re: buying a case 1030 posted by Gary from Muleshoe on September 17, 2010 at 19:17:12:
I find your coments about the 830 suprising We sold many 830 EH and DOMs with COM trans as well as 730s. We have hilly ground around here and the COM was a must. The large frame 30 series COM tractors rarely had a trans problem, and motor problems were generally poor maintanance issues, (loose fan belts, dirt filled radiators, generally the guys that threw the grill screens in the back corner of the shed.) The 730s were exactly the same tractor as the 830s except for engine displacement. They were a bit slugish on hills if weighted to do the same work as a 830. Both pulled 4B plows around here. Most of them we sold are still going. In my estimation the 930 was the best of the large frame 30 series tractors. We always wanted Case to put the converter drive in them to compete with the Oliver 1850s. We could out lug them, but the steep hill farming required shifting gears. 4010s couldn't hold a candle to either for heavy tillage, however they handled great and were nice to operate on balers choppers and haybines. Just my memories of the past!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.