Posted by IOWA NORTHEAST on September 22, 2010 at 15:35:04 from (206.72.18.89):
In Reply to: rant on computers! posted by Iowa Northeast on September 21, 2010 at 20:04:17:
I can certianly understand some advise here, but It is pretty clear a few have never delt with the IRS. I personaly also know of a couple folks that had their identity stolen.
I realize that some contractors spend alot of winshield time, but my work load demands that I am part of the small team, and taking a invoice to a air conditioned building seems a wee bit of a problem.
I also had alot more birthdays than I used to have years ago, and when I get home, the bookwork must wait till a rain day. Or at least that is the best excuse I can come up with for not doing it as often as it should be done.
I must admit, I sure as heck know what direct sun does to recipts, and why it does. My rant is our world is supposed to be getting simpler as we get smarter.
I also enjoy finding recipts from a hundred years ago that were written with a simple old chunk of lead, or a ink pen. Now I can't make it 24 hrs with the new methods of recipts (my original rant).
I also have a scanner, and that is a good idea, but again my rant--why should this be required?
My meds will kick in, and I will probably get over this, but that doesn't mean for one moment that I will not complain about it.
And it does seem like we have kinda accepted this as ok in our world. I may not have to wait in line at the Walmart check out, but It will take about the same amount of time waisted at the office.
They have a new prototype toy I've been told that will alow you to push your shopping cart between two posts, and it will print you a recipt of every item in the shopping cart.
I'm thinking I will try putting my mother in law in the cart with all those metal plates in her head and seeing if it will still work.
Any idea how much bookwork I could have done instead of goofing off here? This seems to be more fun!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.