Posted by SKYBOW on October 01, 2010 at 18:36:00 from (67.55.159.4):
In Reply to: OT specialist visit today posted by larry@stinescorner on October 01, 2010 at 16:32:35:
Larry, I'm 58. 4 years ago I had the lazer roto router procedure instead of the microwave or the knife procedure. The recovery was shorter and after effects were projected to be less damaging. I was fine for about 4 months and then I reverted back to the way I was before the procedure. I put up with it for 3 years and then I went back to get the knife procedure. During the work-up exams they found I had a small site that was cancer. I had a radical prostetcomy on Nov 11th last year. Catheter for 2 weeks, back to work by Jan 3rd. I had good bladder conroll because I did the keegle excersises the Dr gave me. Peed like a 20 year old again. Still haven't got back sessual function. I have dry organism but if the flag doesn't go up the flagpole, then no one salutes it. If the antenna doesn't extend then you get no reception-you get my point. So I go in next week for the implants. My BIL in SE Ohio has the same story. THERE IS NO SUCH THING AS "NERVE SPARING" RADICAL PROTATECTOMY. Never heard of ONE guy who got it back. Hope this gives you some inside information to make your future decisions. E-mail me if I can answer any questions for you. Good luck SKYBOW I had to change the spelling on some words to get by the censors. sorry
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
