I figure if you want to make a deal, come on by my place, and we can discuss it. You need to see what the item is anyway, that way you can't say I misrepresented it. You can either take it as is with the set price, or make me a decent lower offer if you want. Either of us can refuse. I usually figure in a "Bargaining Factor", and figure most others do too who have been around very long. If it's something I see from a long ways off I'm interested in, that may be a little different. I buy a good bit of Ham Radio gear, Ebay, QTH, QRZ, and Craigslist. I try to find out about the seller first, and then either offer a bid of the amount I will go for it, or make contact, and see what we can work out. I try not to offend anyone when it comes to buying and selling. I have a friend who worked at a Cadillac dealership, and I was sitting in their used car office with him one evening after work. A guy drove an old beat up car into the lot, and it looked bad. Smoked and so on. I remarked what it looked like, and what I thought. The friend told me that as far as he was concerned, that was the most precious car in the World right now, and was that man's pride and joy. I went to another office with another salesman, and listened to the deal making. The guy drove out with a much better car, with payments he could make, and was happier than anyone I knew. It was all in how he was treated. Like my Uncle said, "Always treat others the same as you would want to be treated in the same situation". It's always worked.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
