Posted by fergienewbee on October 15, 2010 at 06:55:19 from (99.181.131.186):
In Reply to: O/T Land Measurements posted by fergienewbee on October 15, 2010 at 00:46:01:
Thanks for all the info and comments. Here is my description and a better explanation of what I'm wanting to do. I own the the N 1/2 of the SE 1/4 lying southwesterly of the following line commencing at the N 1/4 post then E 97.16' then S @ 17 deg 5 min 34 sec E 4118.9 feet. This puts the start of the power-line on a road 1/2 mile North of me and 1/2 mile West. That would be the N 1/4 section post. This is the back half of my parcel and marks the west boundary of the power line.
The fence, where remnants remain, was nailed to trees. There are no wood or metal posts. Some of the trees have rotted. Now fallen trees make it difficult. I'll keep looking for the corner "tree" which I beleive is a large oak. Maybe rent a metal detector, but it's just an old rusted barbed wire fence.
The neighbor in back is not a friendly guy and both of our parcels are heavily wooded.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
