Posted by Aleuicius on October 28, 2010 at 16:01:48 from (67.249.138.83):
In Reply to: Wood pellet questions posted by Don-Wi on October 28, 2010 at 15:34:47:
As I understand it: a pound of wood - regardless of type - gives off just so much heat when burned. The differences are that many hardwoods are denser and will fit more pounds into the stove, per loading. Oak is about 42 pounds per cubic foot and the desired hardwoods range down to the mid-thirties. Softwoods are generally less dense, being in the lower thirties down to some pines around 26 pounds per cubic foot. Then again, some softwoods (firs)get up near 40 and some hardwoods (like poplar)down in the twenties. With pellets, I don"t think there would be much difference, as a pound is a pound is a pound - though the softwoods bags may seem slightly larger.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.