Posted by old on November 07, 2010 at 15:14:44 from (4.245.13.50):
Boy wants me to start finding parts for his 1951 Chev pick up so we can put a built 250-6 in it. Looking for some of the old hot rod stuff you could get for them back in the 60s like the extra long intake and the dual exhaust. Plus things like the wiper motor that does not run off vacuum. When done this should have a 4 speed and maybe either an Aux tranny or an over drive to help[ with the mileage on it. Also going with a 3/4 ton rear end so we can beef it up for pulling a camper behind it. Ya I know your going to say why not put a 350 in but he does not want a V-8 and I have this 250 here that I built years ago and has less then 3000 mile on it since built. So any body have an ideas where to find some of the old type performance parts for that engine?? Thanks. Boy will be back home next Sept. and hopes by then that I will have all the parts and maybe part way done build this for him
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
