Posted by MeAnthony on November 19, 2010 at 17:53:39 from (208.100.202.77):
I use a wood stove for heat(have furnace but propane is largely out of my budget); house is 26 x 74 on a full basement.
The wood stove works ok to heat the middle(located centrally, on north side of house) of the house but both ends are chilly.
I have a much larger wood furnace in the basement. However, I can"t afford $500 or so to put up another chimney.
I would prefer to use the basement wood furnace for main heat. This would eliminate pipes freezing(currently no heat in basement), house floors would be much warmer and I can plumb the blower to the existing furnace ducting, allowing me to more evenly distribute the heat.
Here"s the question: can I extend my existing 6" chimney down to the basement and run both stoves off it?
Existing chimney is 6". My thought is to adapt up to 8"(to allow more volume of airflow) at the ceiling, add a T adapter(and reduce back to 6") to attach to main floor wood stove. Remainder of chimney to basement would also be 8". I realize the adapter to 6" at the ceiling would be a choke point, but I can"t afford to buy all new stuff to replace it with 8" right now.
Total rise from basement through roof is about 20".
I expect that the smaller wood stove on the main floor of the house would only be used if we get extremely cold weather(located in south central MI). So most of the time, only 1 stove would be using the chimney.
I certainly don"t want to create a hazardous system. But unfortunately I"m on a very tight(read single parent, working class dog) budget. And it bugs the dickens outta me to hear my kids saying how cold their bedrooms are, so I gotta do something.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
