Posted by shannon from ohio on November 21, 2010 at 18:02:11 from (24.208.184.151):
This message is a reply to an archived post by Justin Robbins on July 27, 2010 at 07:39:55. The original subject was "Kubota ZB600c 2 cyl. diesel.".
If you gravity feed to the injector pump,NO PROBLEM.it will run ok. If tank is below then you"ll need an elec pump. As far as injector pump and injectors: you can take them apart and clean if necessary(Make note on order of dissasembly and reassembly) Mine had stuck pintles in injectors.. As far as the inj pump: You need to remove cover (Oil fill one) to realign rack unit to pump (Easy job as it is like a fork) ""Make sure you note how many shims between inj pump and engine"" CRITICAL!! or it cause engine damage! Usually 2 to 3 shims the same shape as the pump mounting....... Hope this helps and "HAPPY DIESELING".............
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.