Posted by Mike (WA) on November 23, 2010 at 12:30:46 from (69.10.196.7):
In Reply to: OT cows left posted by rrlund on November 23, 2010 at 09:44:49:
We got out of the dairy business gradually, in the summer of '61, I think. I would have been 12. In those days, dairy cows were bought and sold through the livestock auction (not just culls and springers, like now). Our hauler could only haul 5 at a time, and I think he and dad agreed that we didn't want to "flood the market" anyhow.
So it was my job to milk that summer (Surge bucket milkers with surcingles in a 4 cow parlor). Every week, we culled 5 more. I remember one cow we all agreed would be kept until the end- Ione, a very friendly and gentle cow who milked well. The last milking (and watching them go down the road) was sad, BUT I GOT OVER IT! And have been over it ever since!
It was kind of hard on my dad- he felt like he'd failed, and was in a funk for awhile. But he had saved the farm, and 10 years later, split it up and sold it, and retired at age 53. So he got over it, too.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.