Posted by Don-Wi on November 26, 2010 at 19:33:26 from (75.198.67.217):
In Reply to: Today's project posted by Don-Wi on November 26, 2010 at 18:58:14:
The big cast thing is a cast iron strainer. It's got a screen in it similar to the one on the tractor's pump.
I was gonna use the drain plug, but it's a metric thread (M18x1.5) and I don't have the fittings. Was gonna drill one out, but there wasn't enough clearance to get a drill in there between the tractor and the loader frame, which happened to be perfectly in the way. Wasn't gonna take the loader off either.
I originally plumbed it up what must be 8 years ago. Was 18 at the time and not as much thought was put into it. At that time I used a 1/2" line for the suction but the hydraulics were slower than using the tractor's pump in the winter time because it couldn't pull the oil due to it being so thick. Went up to 3/4" suction line, which is a 50% increase in area. Not sure if it'll be a straight line increase in actual increase of volume or if it'll be more of an exponential deal. Either way will be much more bearable. Don't see any reason the spin on filter won't work on it's side like that- it's no different than an engine oil filter really and they're on they're side quite often. Either way is better than nothing which is what it had before.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.