Posted by Tom in TN on December 01, 2010 at 15:26:30 from (68.52.216.19):
In Reply to: Remote Car Starter posted by Mark-Ia on December 01, 2010 at 12:15:02:
Mark,
I've installed two of them. One in a Dodge conversion van and one in a Dodge Grand Caravan. I don't remember the manufacturers of either of them.
The DVDs that were provided with the units made the installation look very easy. In fact, they are a pain in the neck to install. You have to tap into a bunch of wires that are coming out of the steering column. They are under the dashboard and are hard to access. You have to attach the unit to something under the dash. You also tap into the fuse block and have to install a plunger switch that is operated by the hood so that the remote starter won't work when you're working on the engine doing something else.
In both cases, the units worked well for about 6 months and then quit. They were too hard to access to make it worth my while to try to diagnose the problems so I just abandoned them.
Technically, they are a cinch. Just color coded wires, solder, tape and a drill. But you need to plan on four to six hours of standing on your head screwing around under the dash to accomplish the task.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
