Got another one, this one not so much being dumb as just a self created learning experience. I rebuilt a 6-71 Detroit that was missing the plate the emergency shutdown flap seated against. Instead of spending an arm and a leg on a part that wasn't going to be in for several weeks I decided to make one using the gasket as a template to get the engine complete and back in. Simple flat plate with four bolt holes and two big holes, nothing to screw up so it should have worked, right??? WRONG!!!! The engine would run fine at an idle but lost power when racked open to full throttle. I checked everything from the fuel pump to the fuel lines to the size of the orfice in the return line and couldn't find anything wrong. I finally wondered if something had gotten into the blower and pulled the snorkle off the side to take a look. I didn't see a thing wrong but with the snorkle off I fired it up and it ran just fine. The only thing not origionalto the engine was that plate so I thought it had to be the problem. That's when I happened to remember another 6-71 I had under the shed that still had the OEM plate attached so I pulled it. Laying it down on the plate I fabricated the holes were exactly the same size and located in the same place end to end. The only difference in my plate and the OEM was the holes in my plate were 1/2 inch lower than factory. Even though lower they were still well within the intake opening provided on the blower. I haved asked numerous other mechanics over the years who are knowledgable on the Detroits and so far haven't found anyone who can explain what happened.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
