A barn with that little slope on the roof would never withstand the snows we have around here, near Spokane. Our outbuildings are almost always built with a 4/12 or 5/12 pitch, so the snow will slide off the sheetmetal roofs. A couple of years ago, we had over 6 feet of snow accumulation and it brought down lots of buildings, including some pole sheds that had been there for years. Lots of others would probably have come down except for the fact that the owners employed people to shovel or blow the snow off them.
But if your barn has done OK for 50 years, it must be strongly enough built for your area. If it was my roof, I would watch for any drifts developing on it, and would consider shoveling off any areas that got deep. If you do get up there, be super careful, since the snow covered metal will be incredibly slick. If you have access to a small snow blower, that might work well. I hate being on metal roofs when they are dry, much less snow covered! And always have a safety line to grab if I start sliding.
As far as heating the inside of the barn goes, I think you would need a lot of heat. And without a vapor barrier, any combustion heat will result in lots of condensation inside that you will have to deal with somehow. If snow will usually slide or creep down the slope of your roof under normal conditions, it might be worth it to heat the place up.
I hope your weather turns warmer and less snowy. It is flat scary to worry if a roof might come down...Good luck!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
