Posted by jackinok on December 30, 2010 at 07:40:03 from (162.58.82.136):
In Reply to: Re: Beaver slide? posted by Allan In NE on December 30, 2010 at 07:01:58:
over shot was a little different,as you could at least theoretically put hay close to where you needed it in stack .beaverslides(and overshots)were used many many years.And they are still a viable way to put up loose hay.Believe it or not,they were the prototype hay loader of the day.A pickup hay loader was in use at the same time that was simply a beaverslide on a smaller scale with a pickup reel on front.wagon was hooked to rear and hay was picked up either directly off the ground after mowing,or if you were picking up something like alfalfa for instance that would lose its leaves,out of a wind row and loaded on wagon.( very few of these have survived by the way, to find one in working condition is very rare)forking hay ONTO a wagon (if youve never done it) is one of the hardest dirtiest jobs on a farm,These were HUGE labor savers.Balers, when handling hay, are actually somewhat of a compromise. You will arguably lose less hay out of a stack,and can put it up reltivly cheaply(both stored outside of course)but it takes a lot more labor to feed out of a stack in both putting up hay and feeding.Overshots are what most folks are more familiar with in most sections because they could be broken down and moved easier.But in the big range country where you bunched your cattle in winter beaverslides were common.to this day if you move your livestock onto what you might call the home range in winter,loose hay makes perfect sense.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
