Posted by Billy NY on January 05, 2011 at 16:08:43 from (74.67.3.54):
In Reply to: Code question for NYs posted by JayinNY on January 05, 2011 at 15:49:01:
The U.L. fire resistance directory back then should have had tested wall types for that application, most of those wood framed chimneys were covered with gypsum wall board sheathing, (multi layers of same?) possibly fire retardant lumber/cold formed metal framing, all to achieve a specific rating, 1 hr, 1hr or maybe a 3hr rating. It would be reasonable to speculate that the NYS code, local code, etc. would allow something U.L. rated for this kind of building occupancy classification, as designed and shown on drawings submitted for building permit approval by whomever the presiding authority was at the time. Architect/Engineer would have to had shown something specific, because the wall type is kind of unique to what it encases, a flue pipe. The other thing is, what was designed, and what was built. These were " value engineering" designs, as they are much quicker to construct and less costly, condo developers, like the Michaels Group, locally, used this design in most of what they built then, as did many home builders.
I would have to speculate that electrical circuits would not be allowed, 1st due to the wall penetrations and other factors, though a shaft/chase/chimney like this would be a great place to hide a riser, if allowed you would think it would have called for steel conduit and encasement. Just some thoughts about it, I could be way off just the same, but my knowledge comes from commercial construction.
U.L. Fire Resistance Directory is a great resource for designers, it provides tested assemblies, thousands of them. More than likely the designer chose a wall type from it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.