Posted by Bill in Colo on January 11, 2011 at 08:22:32 from (75.107.0.52):
I have two identical grapple forks on loaders same exact cylinder on both,one has adequate grab, the other does not,neither cylinder has any leak off and have been rebuilt in the last two years. One cylinder gets 2500 psi and works well, the other gets 2100 psi and not so well. They cylinders have a 2.5"bore and 8" stroke. How much do I need to increase the bore size to do the same work with 2100 psi as with 2500. Thanks
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
