Posted by Sid on January 20, 2011 at 10:58:50 from (67.210.55.140):
In Reply to: mills posted by Jamo58 on January 20, 2011 at 09:50:39:
1. A burr mill would be two abrasive wheels with a space between them. They rotate in opposite directions the grain would be grain as it was fed between the wheels. The old water powered mills where usually this type.
2. A fanning mill cleans seed by forcing air through or over the grain.
3. A feed grinder grinds grain for feed. The most common is the hammer mill. It is a series of flails on rods that swing when the mill is rotated at a high speed. The flails (hammers) crack or crush the grain that is fed into the mill. The grain is thrown against a screen which is a metal plate with holes in it. the smaller the hole the finer the product.
Note this is not very detailed but a basic description.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
