I have a Daewoo Korando with similar hubs, so on the assumption that one Korean hub is like another, my bet is just a split vacuum tube.
So check all tubes from the hubs back to the solenoid valve (pay attention to any tee joints) & make sure all the rubbers are sound. If all OK, then
Next question: do you have vacuum at the output from the solenoid valve?
If not then check out the valve operation - try a light tap if its stuck etc. & see if the solenoid bit of it works or not. Is it getting power? There's loads of those type of vacuum solenoids on old Mercedes engines, so you should be able to get them from a breaker easily.
Pull off the tubes at each hub & check if you have vacuum at each.
Check the metal tubes where the rubber pipes attach to each hub. Check for corrosion, breaks & whether they are blocked or not.
If all is OK, but still no hub engagement, then the hubs are easy to dismantle (Google for Daewoo or Ssangyong Musso & Korando stuff). Basically the oil seal at the driveshaft side also has to seal the vacuum. If wheel bearings are sloppy, then the vac seal may be lost, so check & adjust if necessary. The outer side is sealed by a diaphragm arrangement & an O ring on the outer hub. You'll see all this as soon as you take the 6 bolts out. There is a nylon top hat type cap attached to the diaphragm that actuates the hub locking, (it's quite easy to work it out when you see it) Check that moves freely (may be a build up of old grease is stopping it) Don't use too much grease when reassembling or you may block the tube when the vacuum sucks.
It's an easy job to do & cheap to fix too - probably just need some new rubber pipe. If the metal pipes in the hub are broken, then it's a bit more involved - you'll need to drill & tap the hub & screw in some brake pipe or similar to receive the rubber tubing.
I can send you a PDF +pics of the =vacuum system if you need? (I can't see how to post a PDF to the forum)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Cautionary Tale - by Ian Minshull. In the early 1950s my father bought an Allis Chalmers B and I used it for all the row crop work with the mangolds and potatoes, rolling and the haymaking on our farm. The farm and the Allis were sold and I have spent a lifetime working on farms throughout the country. I promised myself that one day I would own an Allis. That time event
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
