Posted by Mike (WA) on January 22, 2011 at 10:29:45 from (97.113.254.221):
In Reply to: Good bad of 2040s posted by RG5300 on January 21, 2011 at 17:23:11:
2040 would be plenty of tractor for a small square baler- and a real nice tractor to run, as well. You'll like it. No real need to go with a newer series- in fact, a 2020 would also be fine, if you can find a nice one.
'Course, there's nothing like a 6 cylinder Oliver, with independent PTO, just loafin' along. Smoooooth. Wish I still had the 880.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
