I have done both but I have the overhead type single spring. I used two pieces of re-rod cut to about twelve inches long. You should have a tenson device on the end of the spring which you need to loosen the bolts on it and use the re-rod pcs in the holes on the device a hold it in place and carefully unwind the device and take the tenson off of the spring. BE CAREFULL because it will suddenly unwind if you let it go. Although if the spring is broke there will be no tenson on it. After you in stall the new spring you have to wind the spring back up again. My spring takes about 8 1/2 turns to get the proper tenson on the new spring. Be sure to block the door from coming up as you do it. Also put a clamp or vice grips on the rod that the spring is mounted on to keep it from turning as you wind the spring up. Again,Please be carefull as you wind or unwind that spring. I think I googled it the first time I did it a few years back. They can probably give you better instructions on how to do it. Its really not that hard as long as your carefull and don't let one of them rods loose as your doing it. Home Depot won't even sell you a spring because of the danger involved and lieability. The other type you have two springs, one on each side of the track up above and you just adjust the tenson on the cables that the spring is mounted to. Hope I've helped.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Cautionary Tale - by Ian Minshull. In the early 1950s my father bought an Allis Chalmers B and I used it for all the row crop work with the mangolds and potatoes, rolling and the haymaking on our farm. The farm and the Allis were sold and I have spent a lifetime working on farms throughout the country. I promised myself that one day I would own an Allis. That time event
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
