Posted by Loren in MN on February 01, 2011 at 09:50:32 from (97.116.26.153):
In Reply to: Blade or loader posted by Peat on February 01, 2011 at 05:18:58:
I don't know how heavy your snow gets there or how much you usually get at a time,but here in central MN you can get 14-18" snows but usually only 8-12" at a time. You may laugh, but I only use a Farmall Super C with a 7ft blade. It has 4 rear IHC weights, chains and no fluid in rear. I have no trouble pushing most 12" snowfalls to any distance I wish. It will push 4ft banks easily. A few years back, I thought I'd try to see what the old girl would do, so I plowed my township road with 10 to 20 inch deep snow for 3/4 mile to the county road, just so the neighbors could get out. It was in a 20mph wind with no cab or heat-hauser. The tractor did just fine but I was frozen. It did want to drift back in by the time I had gone the full distance. My D-17 w/loader and my IHC 756 just set in the barn. I think all you need is good traction. Oh, I also prefer a blade to a bucket. I had a loader on the Super-C and it was fast lifting, but wasn't as fast at moving snow as the blade. A neighbor has a newer small Massey Ferguson 4WD with a bucket. We've worked together helping plow an elderly widows 500ft drive and yard area. He had a blade made for his tractor loader after he saw how much more snow I could move with the Super C. I should go out to push a little snow today but I'm waiting for a bit warmer temp.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.