Well I for one will be selling (of giving away) my humble home before July 1st.
Where I live the city adopted the International Property Owners Maintenance Code and my home isn't up to snuff to pass it even though I've live in it since 1991.
One requirement is that both kitchen and bath have ground fault circuit interrupter plug-ins and mine doesn't. The rest of the house has some properly wired three prong outlets but the majority are still two prong.
Ultimately my entire house needs rewired starting with a new service box. Think I care to put that kind of money into a 1920s house that has little value?
The new ordinance states any new outbuildings such as garage must have the same exterior treatment as the house. I'm needing a new garage---where do I buy steel siding? Not aluminum or vinyl, but steel? Guess that means I can't ever replace, only remove the old one.
I figure it is better to just get out of restrictive housing codes and either live in a cardboard box on my farm if I have to or move clear out of the area where I can do what I want and how I want and am welcome to do so. Low population counties will welcome an additional tax payer and I already own property in one of them. I just don't care for the climate there and to be further away from my grand kids.
We also have an ordinance requiring snow removal from sidewalks within hours after a snowfall. I don't object much to that except when I'm out of town or when it is ice instead of snow and melting would be the best option. Just showing how controlling the city wants to be.
Under cap and trade, etc. I think many people will be surprised when they prepare to sell in the future. There was hype anyway about a home being sold as having to have newer energy efficient appliances, furnace, water heater, etc. and the home couldn't be sold until they had such.
I'm simply going to get while the getting is good.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
