Posted by Super Trucker on February 12, 2011 at 05:06:10 from (99.40.111.118):
In Reply to: Oxygen Sensor posted by Bartt on February 12, 2011 at 03:32:09:
Depends on where it is located in the exhaust stream. If it's up in the manifold they aren't the best for doing at home. If it's in the exaust pipe it can be changed in about 10min. Just look for a spark plug looking part with 1-3 wires coming out of it and it will have a connecter on it. You can do it your self for a lot less money. The dealer should only charge about 1hr shop rate. BUT how many O2 sensors do you have? Most newer vehicles have 2-4 sensors. Would hate you replace the wrong one. They usually place them 1 in each manifold on the engine then 1 or 2 [depending on make] down by the cat converter. Hope this helps
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
