Posted by ted regentin on February 12, 2011 at 13:24:21 from (216.110.201.109):
In Reply to: Re: Oxygen Sensor posted by Allan In NE on February 12, 2011 at 06:06:02:
"I'd just about bet that 90% of all O2 sensor replacements are done needlessly."
Just out of curiosity, do you have anything to back up that statement? I do driveability/electrical diagnostics, and I have replaced plenty of oxygen sensors. A good percentage of them are four wire heated sensors that the heater element is open. This problem can be very easily verified using an ohm meter. For the sensors that trouble codes indicate slow reaction or out of range, there are scan tool data streams that show long term adaptives and short term adaptives. Also, some manufacturers use operating cell stratagies that can help verify the problem. I normally can be sure most of the time before I replace an oxygen sensor. After I replace a sensor, I do enough test driving for the ECM to run its monitors that can verify systems operation. There is one specific problem that I will "throw" an oxygen sensor at. Some cars will set catalytic converter efficiency codes. There are times that I cannot be sure if the sensors are causing the problem, or if the cat is bad, so on occasion I will recommend trying new oxygen sensors first, then test driving and recheck the monitors. The reason that I do it this way, is because catalytic converters on some models are rather expensive. By the way, some newer models use something called an "air fuel ratio sensor" instead of the traditional oxygen sensor. I hope that all this isn't too technical for you, Allan, but the point of this post is that there is a lot to proper oxygen sensor diagnostics, and it takes a lot of skill, experience and training to do it properly. My shop probably has over $20,000 just in scan tools and I need a couple more to be efficient. Hope this helps,
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
