Posted by bison on February 14, 2011 at 09:24:34 from (69.168.144.133):
In Reply to: Broken Stud Removal posted by 1 Dollar on February 13, 2011 at 20:05:05:
People that have the notion that one can get a good and stuck broke bolt out with an easyout or lefthand drill bit have obviously never tried it themselves.It might work fine on a bolt that's loose in the treads,but if the bolt was twisted off to start with there is no way. In the latter case welding a nut to it or drilling it out are the only viable options. Drilling gets the hole out of center more often than not unless a precision drill guide is bolted over the broke stump and a milling bit is used cause the broke bolt surface is seldom flat and a drillbit tends to wander to the low spot and one ends up with a hole that thatches tread on one side and leaves half the bolt intact,then what?. I prefer to try the welding first.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.