Posted by glennster on February 15, 2011 at 06:04:18 from (75.57.126.3):
In Reply to: Re: Beaver problem posted by buickanddeere on February 15, 2011 at 05:42:58:
the castor lure shouldnt be put directly on the trap. construct a castor mound on the shore and use the castor lure on the mound. make a climb out leading to the castor mound and in the water set either a drowning snare set or use a bridger body grip trap set on a stabilizer underwater on the approach. a dive pole would be a good idea to get the beaver to dive under the pole directly into the trap. for a dam set, make two small breaks in the dam about 5 feet apart. on the upstream side, directly between the break, make your trap set perpendicular to the dam, using a snare or bodygrip trap, or if the water is shallow, a leg hold trap. the beaver will approach from upstream carrying debris to repair the dam break. if you make the set directly in line with the break, he will trigger the trap with the debris and will miss him. with the double break, they will repair the first break then turn to the second break, swimming directly into the trap. if they are feeding on the trees, locate where they are actively feeding, find the climb out, and the trail they are using. use a snare in the trail, a 10 to 12 inch loop on a locking cable snare will do the job. dont use castor lure on a trail set,. be sure to anchor the snare with a swivel and a length of dog chain. stake the chain below ground so the beaver doesnt chew off the stake and escape. he will be alive in this type of set, so you will need to dispatch him.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.