Posted by Adrian Billheimer on February 23, 2011 at 16:54:07 from (173.86.62.181):
In Reply to: O/T Ford truck posted by .RIVIR. on February 23, 2011 at 16:19:16:
The 460 will fit, you will have to mix and match motor and trany mounts, I once had a 76 f-150, originaly had a 302, I pulled the blown 302 out, put in a 400 and its tranny (c-6) out of a 73 station wagon, later I swapped out the 400 for a 460, I used the tranny, flywheel and starter from the 400 and the 460 engine mounts,also had to use the heavier radiator, and therefore had to change the rad. mount. I think I had to turn the tranny mount and crossmember around. I don't remember which driveshaft I used, but I think I had to put the carrier bearing in the other set of holes on its crossmember. All of this was back in the early 90s.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.