Kind of... There are rods that will run on AC/DC and just on DC. To my knowledge, there are no rods that just run on AC only, but there might be some for exotic metals, etc out there. They must not be very common though.
Of the AC/DC rods, all will run smoother on DC, and get more penetration with a nicer arc, less splatter, easier starts, and no arc-outtages.
6010 is a deep digging electrode that burns through a lot of paint/rust/etc, but only runs on DC.
6011 is the AC version of 6010, same rod but with arc stabilizers for AC current. It doesn't get quite as much penetration, and runs a little differently, and can also be used on DC.
7018 can be run on AC or DC, but I'm told that theres a 7018AC version, that runs better on AC than regular 7018. I have never used that, though...
Most other DC rods (6013, 7014, etc) will also run on AC. I hope that this answers your question...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
